Search

Are you loading data via Ajax and then immediately calling page.info()? If so, recall what the first a in Ajax stands for :-). You need to use initComplete to wait until the data has been loaded. Allan

can be defined after initialisation. You would need to

Thanks Allan. All I needed to do was remove the table parameter on initialisation ;-)

You might be interested in the discussion in this thread about integrating these two extensions: https://www.datatables.net/forums/discussion/22677 . Responsive uses settings derived only from the initial settings. Use responsive.rebuild() to recalculate the class logic. Allan

to _fnGetCellData or an initial call to set prior

for more than the initial load... perhaps sorting the

Hi Tsakal, Ahh I see so I should put it in "initComplete" :)

columns: me.columns, columnDefs: me.renderer, initComplete: function() { } }); This all works

I call it in 'initComplete' $('#myTable').DataTable().page.len($('#myTable').DataTable().ajax.json().iDisplayLength); $('#myTable').DataTable().order($('#myTable').DataTable().ajax.json().aaSorting); $('#myTable').DataTable().draw(); But

handler for initCreate and initEdit. You can even run